|
Colt 1851 Navy Pietta (58c)
|
|
|
Quantity in Basket:
None
Code: Colt_58c
Price: $68.00
Shipping Weight: 0.25 pounds
|
|
This is the 1851 Colt Navy model (36 cal) revolver grip,
made with a slightly shorter top section than the 58a.
It has just slightly different dimensions from the 58a
model, which may fit your particular version better. Be
sure to compare dimensions, and only order one that is
as large or larger in all direcctions compared to your
gun frame or existing grips.
When in doubt, always make a tracing around your existing grips
or cut out an index card template that fits your gun frame
just the way you want the new grips to fit. Mail that to
me, and indicate above with the check box that you are
sending a tracing (or template) so I will wait for it.
- Front edge of grip, height (A) = 0.95 inches
- Overall height of grip (B) = 3.2 inches
- Width of the base (C) = 2.4 inches
- Centerline of front edge to rear edge (D) = 1.7 inches
- Flat across the top (E) = 1.05 inches
Note:
If you want a screw-mounted grip, be sure to check the
appropriate choice above for a 2-piece, screw mount. If you
want the original 1-piece style, then order the 1-piece kit
which comes as two panels and a spacer (3 pieces). If you
want a screw mount style, send a tracing showing the screw
location desired. If you do NOT send a tracing, but indicate
you want the screw mount kit installed, then the location
will be the same as a 1st generation Colt 1873. This may or
may not interfere with the hammer spring on your gun,
depending on exactly where it is located in your particular
clone. It's up to you if you want to take the chance or
send a tracing to make sure.
|
Related Item(s)
Code
|
Name
|
Price
|
Availability
|
|
Colt_58a
|
Colt 1851 Navy (58a)
|
$68.00
|
|
|